Our manual vice grips are ideally suited for capacities of 50kN or less. Available with various capacities, face widths, and face styles, there is a Seatallan vice grip (vise grip to our USA clients) to suit your requirements.
Each vice grip is design and made here in the UK to exceptionally high standards, for consistently accurate testing year in, year out.
Check out our range of pneumatic grips and vices here.
Save time and money - order your new Seatallan vice grips at our online shop, and we'll deliver them from our manufacturing base direct to your door.
A low mass vice grip for very low loads. The jaws are 50mm wide and open up to 4mm. They are rubber coated for maximum friction.
This is a single sided vice grip for thin samples. Rubber coated faces are fitted as standard. The gripping force is applied by a threaded rod which is cross drilled to allow the use of a bar to increase the clamping force.
This grip is similar to ST8 but has the advantage that both sides are adjustable, allowing the sample to be centred. This arrangement gives the best results, avoiding bending forces in the sample and on the loadcell.
A general purpose vice grip for loads up to 10kN. The grip is double sided to allow the sample to be centralised, avoiding bending loads on the loadcell and sample. Sample width with the standard jaws is 50mm, with an opening of 25mm.
A general purpose vice grip for loads up to 20kN. The grip is double sided to allow the sample to be centralised, avoiding bending loads on the loadcell and sample. Sample width with the standard jaws is 50mm, with an opening of 25mm.
Office: +44 (0) 1489 790049
Fax: +44 (0) 1489 790040
Email: sales@seatallan.com
Our mailing address is:
Unit 1 Calcot Mount
Curdridge, Southampton
UK
SO32 2BN
Registered in England No. 3070765
